Home
Up

     Illustration of a Dry Steam Power Plant - Geothermal steam comes up from the reservoir through a production well. The steam spins a turbine, which in turn spins a generator that creates electricity. Excess steam condenses to water, which is put back into the reservoir via an injection well.

Dry Steam Power Plants

Steam plants use hydrothermal fluids that are primarily steam. The steam goes directly to a turbine, which drives a generator that produces electricity. The steam eliminates the need to burn fossil fuels to run the turbine. (Also eliminating the need to transport and store fuels!) This is the oldest type of geothermal power plant. It was first used at Lardarello in Italy in 1904, and is still very effective. Steam technology is used today at The Geysers in northern California, the world's largest single source of geothermal power. These plants emit only excess steam and very minor amounts of gases.

 

 

 

 

Flash Steam Power PlantsIllustration of a Flash Steam Power Plant - Pressurized geothermal hot water comes up from the reservoir through a production well. The water enters a flash tank where it depressurizes and flashes to steam. The steam then spins the turbine, which in turn spins a geneator that creates electricity. Excess steam condenses to water, which is put back into the reservoir via an injection well.

Hydrothermal fluids above 360°F (182°C) can be used in flash plants to make electricity. Fluid is sprayed into a tank held at a much lower pressure than the fluid, causing some of the fluid to rapidly vaporize, or "flash." The vapor then drives a turbine, which drives a generator. If any liquid remains in the tank, it can be flashed again in a second tank to extract even more energy.

 

 

 

 

 

 

 

Illustration of a Binary Cycle Power Plant - Illustration of a binary-cycle power plant. Geothermal hot water comes up from the reservoir through a production well. The hot water passes by a heat exchanger that is connected to a tank containing a secondary hydrocarbon fluid. The hot water heats the fluid, which turns to vapor. The vapor spins a turbine, which in turn spins a generator that creates electricity. The hot water continues back into the reservoir via an injection well. This closed-loop system produces no emissions.

 

Binary-Cycle Power Plants

 

Most geothermal areas contain moderate-temperature water below 400°F) Energy is extracted from these fluids in binary-cycle power plants. Hot geothermal fluid and a secondary (hence, "binary") fluid with a much lower boiling point than water pass through a heat exchanger. Heat from the geothermal fluid causes the secondary fluid to flash to vapor, which then drives the turbines. Because this is a closed-loop system, virtually nothing is emitted to the atmosphere. Moderate-temperature water is by far the more common geothermal resource, and most geothermal power plants in the future will be binary-cycle plants.